Be aware of this if you are using a water heater rod, one more mistake you have to make.

Extreme caution should be exercised when using electrical appliances. Be it summer or winter, different types of electrical equipment are used. Room heaters, water heaters and geysers are widely used in winter season. Now that winter is here once again, hot water is needed. To avoid the cold, geysers or water heater rods, also called immersion rods, are used to heat water in most homes. If you are also going to use it, there is good news for you.

Geysers are actually very expensive and not everyone can afford them. In such situations, many times people use water heater rods to heat water. Water heater rods heat water but are also very dangerous. So, if we are a little careless in its use, it can cause huge harm. These are more dangerous than geysers. If you use an immersion wand, there are a few things you should keep in mind.

Never make this mistake with a dip stick

  1. If you are going to use a water heater rod to keep out the cold, you should avoid using an old heater rod.
  2. Always use a water heater rod in a plastic bucket. Put it on an iron bucket even by mistake.
  3. Turn on the water heater only when the rod is immersed in water. Do not touch the bucket after switching on.
  4. If the bucket is low on water, never add water to it while the heater is on. This can cause you severe electric shock.
  5. It is often seen that people start taking hot water from the bucket as soon as the heater is switched on when required. Do not make such a mistake even by mistake.
  6. If the water has heated up and you have turned off the water heater rod, do not remove it from the water immediately, remove the rod from the water only 15-20 seconds after switching off.
  7. Many people leave the water heater rods on for hours. You should never make such a mistake. If you heat water with a heater rot, heat it only to the optimum temperature.
  8. If you are going to buy a new immersion rod, buy only ISI marked heaters. Only buy immersion rods with voltages between 1500-200 watts and 230-250 watts.
  9. Many people use immersion sticks in less than half a bucket of water. You should never make such a mistake. Put enough water in the bucket so that the rod is completely submerged.

Also Read- 200MP Camera, 256GB Storage, Samsung Galaxy S23 Ultra Price Raised in Flipkart

Leave a Comment

Exit mobile version